Volkswagen Crafter 2.0 TDI Stage 1: 140→180hp | DMS Tuned

Volkswagen Crafter 2.0 TDI Stage 1: 140→180hp

Volkswagen Crafter 2.0 TDI Stage 1: 140hp → 180hp, 340→405Nm. Custom calibration written for your car and proven on our dyno, not an off-the-shelf file.…

Volkswagen Crafter Stage 1: 140 hp → 180 hp

Factory output for the Volkswagen Crafter 2.0 TDI is 140 hp and 340 Nm. A Stage 1 remap targets 180 hp and 405 Nm — 40 hp (+29%) and 65 Nm (+19%).

Those are the figures we work to on this engine. They are a starting point, not a promise: the number we hand back is the one your car makes on our dyno, measured before and after on the same day, in the same conditions.

Where the 65 Nm shows up

On a diesel the useful change is torque, not peak power. Going from 340 Nm to 405 Nm fills in the mid-range, which is where a Volkswagen Crafter actually spends its time — pulling from 1,800 to 3,000 rpm in a high gear, overtaking without dropping two gears, towing or carrying weight without the engine falling on its face.

Peak power moves too, 140 hp to 180 hp, but you will feel the 65 Nm far more often than the 40 hp.

What Stage 1 involves on a Volkswagen Crafter

We read the ECU, log the car as it stands, and put it on the dyno to confirm the 140 hp baseline — a tired or faulty engine gets diagnosed before it gets mapped, not after.

The calibration is written for your car, not pulled from a file library. We adjust fuelling, ignition timing, injection timing and boost, then re-run the dyno to verify the 180 hp and 405 Nm figure and check knock, lambda and temperatures under load.

Turnaround is same-day for most cars. Stock file is archived, so the car can go back to standard whenever you want.

Which Volkswagen Crafter this covers

These figures are for the 2.0 TDI as fitted 2017–2020. Engine code and ECU type decide what is possible, so send us the registration or VIN and we will confirm the exact variant before you book anything.

Volkswagen Crafter remap price and booking

Stage 1 for the Volkswagen Crafter 2.0 TDI starts at €450, including the dyno runs before and after and the stock-file archive.

We work from Leoforos Karamanli 127, Artemida 19016, east of Athens, and tune remotely across Europe where the ECU allows it. WhatsApp +30 697 728 8810 with your registration for a straight answer on your car.

Other Volkswagen Crafter engines

More Volkswagen tuning

More from DMS Tuned

WhatsApp +30 697 728 8810 · Επικοινωνία · Τιμές · Δυναμόμετρο · ECU Tuning