Skoda Superb 2.0 CR TDI Stage 1: 140→190hp | DMS Tuned

Skoda Superb 2.0 CR TDI Stage 1: 140→190hp

Skoda Superb 2.0 CR TDI Stage 1: 140hp → 190hp, 320→415Nm. ✓ We have run this car on our own dyno — measured sheet on file. Custom DMS calibration written…

✓ We have run a Skoda Superb on our own dyno

This is not a figure copied from a database. A 2.0 CR TDI of this exact power variant has been on our rollers, and we hold the DynoRevolt sheet for what it measured. Ask to see it. For before-and-after runs on the same machine, all 86 of ours are published in full on our dyno page — nobody else shows you theirs.

Skoda Superb Stage 1: 140 hp → 190 hp

Factory output for the Skoda Superb 2.0 CR TDI is 140 hp and 320 Nm. A Stage 1 remap targets 190 hp and 415 Nm — 50 hp (+36%) and 95 Nm (+30%).

Those are the figures we work to on this engine. They are a starting point, not a promise: the number we hand back is the one your car makes on our dyno, measured before and after on the same day, in the same conditions.

Where the 95 Nm shows up

On a diesel the useful change is torque, not peak power. Going from 320 Nm to 415 Nm fills in the mid-range, which is where a Skoda Superb actually spends its time — pulling from 1,800 to 3,000 rpm in a high gear, overtaking without dropping two gears, towing or carrying weight without the engine falling on its face.

Peak power moves too, 140 hp to 190 hp, but you will feel the 95 Nm far more often than the 50 hp.

What Stage 1 involves on a Skoda Superb

We read the ECU, log the car as it stands, and put it on the dyno to confirm the 140 hp baseline — a tired or faulty engine gets diagnosed before it gets mapped, not after.

The calibration is written for your car, not pulled from a file library. We adjust fuelling, ignition timing, injection timing and boost, then re-run the dyno to verify the 190 hp and 415 Nm figure and check knock, lambda and temperatures under load.

Turnaround is same-day for most cars. Stock file is archived, so the car can go back to standard whenever you want.

Which Skoda Superb this covers

These figures are for the 2.0 CR TDI as fitted 2008–2015. Engine code and ECU type decide what is possible, so send us the registration or VIN and we will confirm the exact variant before you book anything.

Skoda Superb remap price and booking

Stage 1 for the Skoda Superb 2.0 CR TDI starts at €450, including the dyno runs before and after and the stock-file archive.

We work from Leoforos Karamanli 127, Artemida 19016, east of Athens, and tune remotely across Europe where the ECU allows it. WhatsApp +30 697 728 8810 with your registration for a straight answer on your car.

Other Skoda Superb engines

More Skoda tuning

More from DMS Tuned

WhatsApp +30 697 728 8810 · Επικοινωνία · Τιμές · Δυναμόμετρο · ECU Tuning