Toyota Proace Verso City 2.0 BlueHDi Stage 1 Remap: 180→209hp

Toyota Proace Verso City 2.0 BlueHDi Stage 1 Remap: 180→209hp

Toyota Proace Verso City 2.0 BlueHDi Stage 1: 180hp → 209hp, 400→462Nm. Validated DMS calibration, proven on our dyno — not an off-the-shelf file. From…

Toyota Proace Verso City Stage 1: 180 hp → 209 hp

Factory output for the Toyota Proace Verso City 2.0 BlueHDi is 180 hp and 400 Nm. A Stage 1 remap targets 209 hp and 462 Nm — 29 hp (+16%) and 62 Nm (+16%).

Those are the figures we work to on this engine. They are a starting point, not a promise: the number we hand back is the one your car makes on our dyno, measured before and after on the same day, in the same conditions.

Where the 62 Nm shows up

On a diesel the useful change is torque, not peak power. Going from 400 Nm to 462 Nm fills in the mid-range, which is where a Toyota Proace Verso City actually spends its time — pulling from 1,800 to 3,000 rpm in a high gear, overtaking without dropping two gears, towing or carrying weight without the engine falling on its face.

Peak power moves too, 180 hp to 209 hp, but you will feel the 62 Nm far more often than the 29 hp.

What Stage 1 involves on a Toyota Proace Verso City

We read the ECU, log the car as it stands, and put it on the dyno to confirm the 180 hp baseline — a tired or faulty engine gets diagnosed before it gets mapped, not after.

The calibration is written for your car, not pulled from a file library. We adjust fuelling, ignition timing, injection timing and boost, then re-run the dyno to verify the 209 hp and 462 Nm figure and check knock, lambda and temperatures under load.

Turnaround is same-day for most cars. Stock file is archived, so the car can go back to standard whenever you want.

Which Toyota Proace Verso City this covers

These figures are for the 2.0 BlueHDi as fitted 2019–2023. Engine code and ECU type decide what is possible, so send us the registration or VIN and we will confirm the exact variant before you book anything.

Toyota Proace Verso City remap price and booking

Stage 1 for the Toyota Proace Verso City 2.0 BlueHDi starts at €450, including the dyno runs before and after and the stock-file archive.

We work from Leoforos Karamanli 127, Artemida 19016, east of Athens, and tune remotely across Europe where the ECU allows it. WhatsApp +30 697 728 8810 with your registration for a straight answer on your car.

Other Toyota Proace Verso City engines

More Toyota tuning

More from DMS Tuned

WhatsApp +30 697 728 8810 · Επικοινωνία · Τιμές · Δυναμόμετρο · ECU Tuning